TECHNICAL SPECIFICATIONS
Measurement range:
PERCENTAGE OPACITY N 0-99.9%; res. 0.1
ADSORPTION COEFFICIENT k 0-9.99; m-1 res. 0.01
Rev-counter measures through the analysis of the alternate residual signal of the battery and through the engine's noise: 0 - 9990 rev/min ris.10
Engine temperature (sensor in oil measurement “sump”): from 5° to 150°C, resolution 1°C
Operating temperature: from + 5° to 40°C
Temperature controlled measurement chamber: from 75 to 90°C
Light source: High efficiency light diode
Exhaust fume temperature measurement
Fume pressure change check
Fan operation check
Zero reset: automatic
Maximum pre-heating time: 5 minutes
Automatic calibration
Power: 220 volts alternating current
Automatic protective slide soiled check
Storage temperature: from -20°C to +60°C
Measurement module dimensions: 470 x 230 x 220 mm
Measurement module weight: 7 kg.
Serial output: RS232 standard

GAS BOX

TECHNICAL SPECIFICATIONS
Measurement range:
CO: 0 - 9,99 % Vol. ris. 0,01
CO2: 0 - 19,9 % Vol. ris. 0,1
HC: 0 - 9999 ppm Vol. ris. 1( hexane)
O2: 0 - 21,4 % Vol. ris. 0,1
NO: 0 - 2000 ppmVol. ris. 5 (optional)
NO2: 0 - 2000 ppmVol. ris. 5 (optional)
Lambda: 0,5 - 1,500 ris. 0,01
Induction tachometer: 0 - 9990 rev/min ris. 10
Engine temperature probe: 45 - 150 °C ris. 1
Ambient temperature probe: 0 - 45 °C ris. 1
Ambient pressure probe: 800 -1060 mbar ris. 1
Operating temperature: +5 - +40 °C
Automatic pressure compensation: 850 - 1050 mbar
Measure gas intake: 7 l/min (about)
Condensation discharge: Continuous and automatic
Response time: <10 sec (probe length 3 mt.)
Heating time: 60 sec - 5 minutes (max)
Power: Power 230 [V], 50/60 [Hz]
Power voltage ±10%, automatic note with error viewing for variations > ±10% (fuse 2 [A]).
Reset: electronical and automatic
Calibration: electronical and automatic (only with a sample gas cylinder)
Serial output: RS232 standard